of thermal insulation boards. • It is a necessary component and part of the perimeter insulation at ground level (waterproofing zone), when installing the External Thermal Insulation Composite System, THERMOSEAL of DUROSTICK, or any other such system, on wall surfaces close to or touching the ground. USE: Surface preparation: The proper preparation ensures excellent results. Concrete walls: Remove all concrete wood ties, polystyrene as well as all protrusions. Cut all formwork pins and snap ties, 2-3cm deep and coat them with the corrosion inhibitor, RUST FREE POWDER of DUROSTICK. After completion, seal the holes using D-55, DUROFIX, D-11 SUPER FAST or DS-247 of DUROSTICK. Then, clean all surfaces from any loose materials, oils and salts using the biodegradable cleaner, BIO-CLEAN INDUSTRIAL of DUROSTICK. Application: Empty the container with the acrylic emulsion (component B) in a clean container and add slowly, while mixing continuously, the cement mortar (component A). It is recommended to use a low rpm electric mixer, equipped with the ap-propriate mixing attachment. The mixture remains workable for about 2 hours. Apply on well soaked surfaces with an emulsion brush or roller in 3 crosswise coats, with thickness of 1mm each one. The new coat must be applied when the previous becomes walkable or dry to the touch (wall and other surfaces). If the previous coat is allowed to cure, soak the surface again. The product should not be applied at temperatures below +5°C or when there is a chance of rain the next 6 hours. ATTENTION: For absolutely secure waterproofing results and when applying in tanks, first create a curved cement coving around all junctions between floor and walls, and between second and third coat of HYDROSTOP WATERTANK (PROFESSIONAL), apply 20cm wide strips of the fiberglass mesh DS-490 of DUROSTICK. TECHNICAL SPECIFICATIONS (Measurement conditions 20°C και 50% R.H.) • Form - Color: Component A: Cementitious mortar - Gray / Component B: Condensed acrylic polymer. Flexible membrane after application - White • Mixing ratio (14kg packaging): Component A: 10kg mortar / Component B: 4.0lt resin • Mixing ratio (35kg packaging): Component A: 25kg mortar / Component B: 10lt resin • Application thickness: 1mm / coat • Application temperature: From +5°C to +35°C • Temperature resistance: From -30°C to +90°C •Mixing time: 3-4 minutes • Pot life: Approximately 2 hours • Foot traffic: After 3-4 hours • Shrinkage: • If you need better workability of the mixture, the first coat can be diluted 5% to 10% with clean, fresh water.
RkJQdWJsaXNoZXIy MTk0OTg2