PROPERTIES Brushable cementitious waterproofing mortar with excellent adhesion. It fully waterproofs surfaces due to its polymer and water repelling ingredients. D-1 is suitable for positive (preventive exterior application) and negative (interior application for repair purposes) hydrostatic pressure applications. It is resistant to frost and is water vapour permeable (breathable). Classified as product for surface protection of concrete surfaces (c), per EN 1504-2 (principle 2/MC/ moisture control). APPLICATIONS It is applied on surfaces of concrete elements, walls, floors, on surfaces of bricks, cement blocks, in cement mortars, plaster, aircrete, etc. Ideal for the exterior waterproofing of basements and walls, prior to backfilling. Sealed surface with D-1 has to be protected by a drainage membrane (dimpled membrane). D-1 is ideal even for expost waterproofing of vertical or horizontal interior surfaces after removing the plaster with moisture, throughout the area. Excellent for waterproofing underground floors and ground level floors protecting them from rising damp, water tanks, swimming and athletic pools, bathrooms and showers, flower planters, air shafts and tunnels, walls made of brick or concrete blocks before applying the scratch coat of plaster. The product is also recommended for pitched concrete roofs before lining with clay roofing tiles, north facing walls and generally any mineral surface exposed to partial or continuous moisture. USE Surface preparation: Remove all wood wedges, polystyrene and sharp protrusions. Cut the snap ties and tie rods 2-3cm deep and coat them using RUST FREE POWTECHNICAL SPECIFICATIONS (Measurement conditions 20°C and 50% R.H.) • Form - Color: Cementitious mortar - White, gray • Bulk density of dry mortar: 1.10±0.05kg/lt • Bulk density of fresh mortar: 1.60±0.05kg/lt • Maximum grain size: 0.6mm • Water requirement: 6.0lt Brushable waterproofing mortar for walls,
RkJQdWJsaXNoZXIy MTk0OTg2